Ford 6W1Z-54644A22-AAC
Armrest Assembly, Camel

The front seat armrest service begins with removing two pivot screw covers. When the seat armrest stays in vertical position, pushing the locking tab inside from left side enables armrest impact locking pin reset. Proceed by uninstalling the pivot screws present on both sides before removing the seat armrest. Opening the seat armrest lid starts with pushing the left latch button followed by operation of the check lever to reset the buttons and partially close the lid. The seat armrest lid assembly can be lifted off by pushing on the right release button. Before installing the seat armrest lid users must first engage the check lever to reset the latch mechanism before pressing the passenger side button. The seat armrest lid must be placed on the base passenger side before gently pulling it towards the driver side to secure maximum connection. The lid engaging process begins by using the check lever for button depression along with simultaneous driver side button pressing until you hear the "pop" which verifies proper lid engagement before releasing controls. Press the check lever before releasing it and pressing the driver side latch button followed by dropping the lid from 45 degrees to check proper closure. Check the retention by opening and closing the lid three times from each side. You should conclude by reinstalling the armrest and then tightening the two pivot screws prior to securing the two pivot screw covers.

The service process for front seat armrest begins by taking away the two pivot screw covers. A vehicle armrest set in vertical position requires pushing its left-side locking tab to reposition the armrest impact locking pin. Detach the pivot screws from both sides followed by removing the seat armrest. The seat armrest lid removal process starts with opening the driver side latch button followed by resetting the check lever which allows refastening of the two latch buttons then closing the lid part-way. Users can uninstall the seat armrest lid assembly by pressing the passenger side latch button. Installation requires users to press the check lever one time to reset the latch mechanism and next pressing the passenger side latch button. Put the seat armrest lid on the passenger side of the base and guide it toward the driver side to achieve maximum engagement. After engaging the check lever maintain pressure on it to activate the driver side latch button thus creating a "pop" noise and complete lid engagement before releasing both controls. Secure the seat armrest lid by dropping it at a 45-degree angle after releasing the check lever and driver side latch button. Proof of correct retention involves opening and closing the lid thrice using each side to verify proper fit. Place the seat armrest into position and install the pivot screws together with their covers.

Start by removing the two pivot screw covers.

Begin by removing the rear seat backrest.

Remove the rear seat backrest.