Ford YW1Z-19805-CA
Blower Motor

The servicability of the blower motor begins with removing its screw and relocating the windshield washer fluid reservoir. First remove the screws located at the rear of the right-hand fender apron before repositioning it. You must disassemble the wire harness connector from its retainer before disconnecting the wire harness connector. The blower motor removal requires both its hose to be removed first and then the screws to be removed next. Together with the blower motor's wheel removal you need to detach the push clip before proceeding. Always remove corruption from the blower motor shaft before reusing any wheel to avoid damaging the wheel mounting diameter. The installation process requires the opposite steps of those used during removal.

The blower motor servicing requires removal of the windshield washer fluid reservoir screw then its placement in a new position. Start by removing screws which are installed at the rear of the right-hand fender apron before relocating the apron. The wire harness connector needs disconnecting from its retainer before you detach the wire harness connector. Remove the hose before taking out the screws that detach the blower motor. Extraction of the wheel begins by removing the push clip followed by separating it from the blower motor. The blower motor shaft should be cleaned from corrosion before reusing a wheel because cleansing protects the wheel mounting diameter from possible damage. The final step of installation consists of carrying out the removal procedure in reverse order.