Ford XF5Z-3A674-BA
Power Steering Pump

The initial step to service a power steering pump starts with power steering pulley removal and then removal of the high-pressure hose from the pump. Workers should begin by removing both the connecting bolt and then proceeding to remove the hose. First remove the clamp from the power steering return hose before taking it out. First disconnect the electrical connector from the power steering pump before removing its rear bolt. Use your tools to remove the front installation bolts after which you should replace the power steering pump. The power steering pressure hose installation requires a new teflon seal on both fittings before hose connection while assuring thread cleanliness and eliminating all debris. Exit the installation by executing the steps of reverse removal.

Service of the power steering pump starts with eliminating the power steering pulley. First remove the high pressure hose power steering bolt and after that disconnect the hose from its fittings. You should remove the power steering return hose after unclipping its holding clamp. Unplug the power steering electrical connector then remove the rear power steering pump bolt. Take off the power steering pump front bolts before extracting the power steering pump from its position. You must replace the fittings' teflon seal of the power steering pressure hose during installation before attaching the hoses. Also check that the threads remain free from debris. The installation will end when you perform the reverse steps of removal.