FordParts
My Garage
My Account
Cart
Axle Housing - Rear
2000 Ford Crown Victoria Drive Shaft, Axle Shaft
Currently shopping for
2000 Ford Crown Victoria
Change VehicleCategories Close X
Currently selected
Suspension
Other Categories
A/C & Heating
Air & Fuel Delivery
Belts & Cooling
Body & Hardware
Brakes
Charging & Starting
Driveline & Axles
Electrical
Emission Control & Exhaust
Engine
Headlights & Lighting
Interior & Exterior Trim
Maintenance & Lubrication
Steering
Transmission
Categories Close X
How to use OE catalog
Diagram (1 of 1): Rear Suspension - Axle Housing
Sort by:
Ref No.
Ref No.
Part No. & Part Description
Price & Qty.
Part No. &
Part Description
Part Description
- 1
- 1
- 2
- 3
MSRP: $24.17 Your Price: $17.041
- 5
MSRP: $346.50 Your Price: $235.971
OEM 2000 Ford Crown Victoria Parts for Axle Housing - Rear
Genuine OEM 2000 Ford Crown Victoria parts are made using the original design, the high standards, in the Ford official factories, and all of these ensure that they always fit perfectly and easily. FordPartsDeal.com is a trusted source for finding these authentic OEM Axle Housing - Rear parts at very competitive prices. Our professional team is here to help you choose the right 2000 Ford Crown Victoria Drive Shaft, Axle Shaft, and our fast delivery options ensure that your parts are always delivered quickly.
Axle Shaft, Drive Shaft Installation and Repair Tips for 2000 Ford Crown Victoria
- Q: How to Service and Repair the Drive Shaft on 2000 Ford Crown Victoria?A: In order to service the drive/propeller shaft, lift up the vehicle and identify the drive shaft. Take out the bolts, push down the driveshaft and insert the extension housing. Check and grease the slip-yoke spline. Install driveshaft, matching marks and undo the process of removal to complete the installation.
- Q: How to service and repair the axle shaft on 2000 Ford Crown Victoria?A: In order to service the axle shaft, lug nuts should be loosened without heat, remove the center cap, and air suspension should be turned off. Take out the back wheel, differential cover and drain oil. Disassemble the brake parts, remove the shaft of the differential pinion very carefully and re-install. Apply lubricants to seals, replace parts and wipe down surfaces and reassemble.