FordParts
My Garage
My Account
Cart
OEM 2000 Ford Crown Victoria ABS Control Module
Anti Lock Brake Control Module- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 ABS Control Modules found
2000 Ford Crown Victoria Control Module Part Number: XW7Z-2C219-AA
Product Specifications- Other Name: Control; ABS Control Module
- Manufacturer Note: w/ Traction assist
- Base No.: 2C219
- Item Weight: 1.70 Pounds
- Item Dimensions: 2.7 x 6.4 x 7.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW7Z-2C219-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Crown Victoria Control Module Part Number: F8VZ-2C219-BA
Product Specifications- Other Name: Control; ABS Control Module
- Manufacturer Note: ECU only, w/o Traction assist
- Base No.: 2C219
- Item Weight: 1.80 Pounds
- Item Dimensions: 2.6 x 6.4 x 7.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F8VZ-2C219-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Crown Victoria ABS Control Module
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Crown Victoria ABS Control Module available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Crown Victoria ABS Control Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Crown Victoria ABS Control Module Parts Q&A
- Q: How to Bleed the Brake System After Replacing the Front ABS Control Module on 2000 Ford Crown Victoria?A: The first action for bleeding the brake system follows a sequence that starts with cleaning the brake master cylinder filler cap from dirt then filling the reservoir with specific brake fluid. Mount the clear waste line onto the RH rear bleeder screw while directing its other end into a container holding the recommended brake fluid. A maintenance specialist should tighten the RH rear bleeder screw when an assistant applies pressure to the brake pedal while a brake fluid stream runs out. Perform this procedure again until you see clear fluid coming out without bubbles in the brake master cylinder reservoir while you keep filling the reservoir. Complete the bleeding procedure by tightening the RH rear bleeder screw and removing its waste line and then follow with the bleeding sequence for the LH rear screw followed by the RH front disc brake caliper bleeder screw and ending with the LH front caliper bleeder screw. Attach the DCL cable adapter of the scan tool to the Data Link Connector under the dash then proceed with following the instructions on the tool. The system bleed procedure should be performed again following the previously described method.