FordParts
My Garage
My Account
Cart
OEM 2000 Mercury Sable Throttle Body
Fuel Injection Throttle Body- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Throttle Bodies found
2000 Mercury Sable Throttle Body Part Number: 3F1Z-9E926-AA
Product Specifications- Other Name: Body Assembly - Carburetor Throttle; Fuel Injection Electronic Throttle Body Assembly
- Replaces: YF1Z-9E926-AB
- Base No.: 9E926
- Item Weight: 2.00 Pounds
- Item Dimensions: 6.1 x 4.5 x 10.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F1Z-9E926-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Sable Throttle Body Part Number: 1F1Z-9E926-AB
Product Specifications- Other Name: Body Assembly - Carburetor; Fuel Injection Throttle Body
- Base No.: 9E926
- Item Weight: 1.60 Pounds
- Item Dimensions: 7.8 x 6.2 x 5.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1F1Z-9E926-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Sable Throttle Body
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Mercury Sable Throttle Body available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Mercury Sable Throttle Body as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Mercury Sable Throttle Body Parts Q&A
- Q: How to service and repair the throttle body on 2000 Mercury Sable?A: A technician should start any throttle body maintenance by disconnecting the battery ground cable. To detach the snow shield start by uninstalling the air cleaner outlet tube followed by removal of its pin-type retainers. After disconnection of the throttle body components consisting of accelerator cable and speed control actuator cable and throttle return spring place the accelerator cable bracket to the side. The service of the intake manifold support bracket starts by taking out three flexible fuel engine bolts and one gasoline engine bolt as well as a nut. Disassemble the throttle body by removing one stud bolt and three bolts that leads to a disconnection of the electrical connector for the Throttle Position (TP) sensor. The installation requires removing the throttle body gasket along with throttle position sensor from the system. Following the reversal of removal steps will result in proper throttle body installation.