FordParts
My Garage
My Account
Cart
OEM 2002 Ford Crown Victoria Brake Pads
Disc Brake Pad Set- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Brake Pads found
2002 Ford Crown Victoria Brake Pads Part Number: 2U2Z-2V001-ZA
$50.52 MSRP: $68.75You Save: $18.23 (27%)Product Specifications- Other Name: Pad - Brake; Front Pads
- Manufacturer Note: Motorcraft SuperDuty Brake Pads
- Replaces: BRF-748-A, F8VZ-2001-AA, F8AZ-2001-CA
- Base No.: 2V001
- Item Weight: 6.80 Pounds
- Item Dimensions: 2.6 x 5.5 x 9.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2U2Z-2V001-ZA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Ford Crown Victoria Brake Pads Part Number: 2W1Z-2200-AA
Product Specifications- Other Name: Kit - Brake Shoe And Lining; Disc Brake Pad Set; Rear Pads
- Replaces: 1W1Z-2200-BA
- Base No.: 2200
- Item Weight: 3.20 Pounds
- Item Dimensions: 3.1 x 3.7 x 8.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2W1Z-2200-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Ford Crown Victoria Brake Pads
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Ford Crown Victoria Brake Pads available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Ford Crown Victoria Brake Pads as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Ford Crown Victoria Brake Pads Parts Q&A
- Q: How to service and repair the rear brake pads on 2002 Ford Crown Victoria?A: The first step for servicing and repairing rear brake pads requires an inspection of their condition followed by replacement if their wear exceeds the specifications. The removal of rear wheel brake hose is not required for this procedure. Put on protective gear to remove the rear disc brake caliper but keep away all fluids and contaminants from contacting the brake pads. The brake pads must be removed by forcing them inward then rotating them upwards while protecting the piston and boots with a block of wood or used pad to guide the caliper piston into the rear disc brake caliper. The slippers need to be kept free of contaminants and should be in good working order. Installation of new brake pads should occur in complete axle pairs to prevent a single-side installation of fresh pads on a vehicle. Check the brake operation before installing the rear disc brake caliper.