FordParts
My Garage
My Account
Cart
OEM 2002 Ford Crown Victoria Door Latch Assembly
Door Latch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Door Latch Assemblys found
Product Specifications- Other Name: Latch; Door Latch Assembly, Front Right; Door Lock; Lock; Door Latch Assembly
- Position: Front Passenger Side
- Replaces: 6W7Z-5421812-B, 6W7Z-5421812-A
- Base No.: 21812
- Item Weight: 1.70 Pounds
- Item Dimensions: 8.3 x 4.6 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 9W7Z-5421812-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Actuator Assembly; Door Lock Actuator Motor, Rear Left, Rear Right; Door Lock Actuator Motor; Door Lock Actuator; Actuator
- Position: Rear Passenger Side
- Replaces: F8AZ-5426594-AA
- Base No.: 26594
- Item Weight: 0.60 Pounds
- Item Dimensions: 6.2 x 19.4 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F8AZ-5426594-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Ford Crown Victoria Door Latch Assembly
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Ford Crown Victoria Door Latch Assembly available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Ford Crown Victoria Door Latch Assembly as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Ford Crown Victoria Door Latch Assembly Parts Q&A
- Q: How to service and repair the front Door Latch Assembly on 2002 Ford Crown Victoria?A: The service and repair of the front door latch starts with peel-off of the front door trim panel and watershield. You should first remove the screw before pivoting the door latch release handle to detach it from its rod. Open the clip to unlock the actuating rod before you disconnect both the door lock cylinder rod and electrical connectors. First disconnect the electrical connector before removing the rivet then the screws to take out the door lock actuator from the latch. Finally, remove the door latch. The installer should carry out the removal steps in reverse order when installing the component back into its original position.