FordParts
My Garage
My Account
Cart
OEM 2002 Mercury Mountaineer Bumper
Bumper Fascia- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Bumpers found
2002 Mercury Mountaineer Bumper Cover Part Number: 1L2Z-17K835-YB
Product Specifications- Other Name: Cover
- Manufacturer Note: Paint to match
- Base No.: 17K835
- Item Weight: 11.80 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1L2Z-17K835-YB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Mercury Mountaineer Bumper Cover Part Number: 1L2Z-17K835-XB
Product Specifications- Other Name: Cover
- Base No.: 17K835
- Item Weight: 10.50 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1L2Z-17K835-XB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Mercury Mountaineer Bumper Cover Part Number: 1L2Z-17D957-UA
Product Specifications- Other Name: Cover
- Base No.: 17D957
- Item Weight: 9.40 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 1L2Z-17D957-UA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Mercury Mountaineer Bumper
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Mercury Mountaineer Bumper available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Mercury Mountaineer Bumper as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Mercury Mountaineer Bumper Parts Q&A
- Q: How to service and repair the front bumper cover on 2002 Mercury Mountaineer?A: Service and repair of front bumper cover begins with removing the radiator grille sight shield by unbolt its screws then freeing the retaining clips. Service the parking lamp assemblies by taking off electrical connectors while unscrewing the two bolts that exist on each side. Removing the front headlamp assemblies begins with pulling at the upward direction until all four tabs release while disconnecting their electrical connectors. The first step requires the removal of lower radiator air deflector bolts then fender splash shield screws are removed one at a time from each side with three bolts total. To extract the front bumper cover you must remove two fender-opening bolts situated on each side along with six locking tabs and unclip them before extraction. Run the opposite steps to reinstall the components.