How to service the air inlet blend door actuator on 2003 Ford Focus?

In order to service, the air inlet blend door actuator, unhook the glove compartment and open it. Disconnect the screws and the plugs to remove the air recirculation flap servo motor. Make sure that the servo motor rests properly on the shaft and then assemble all the parts again and verify that the air recirculation flap is working.

OEM 2003 Ford Focus Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2003 Ford Focus Actuator Part Number: YS4Z-19E616-AA
Product Specifications
- Other Name: Motor Assembly; HVAC Air Inlet Door Actuator; HVAC Heater Blend Door Actuator
- Base No.: 19E616
- Item Weight: 0.50 Pounds
- Item Dimensions: 5.3 x 4.5 x 2.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YS4Z-19E616-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2003 Ford Focus Submodels:
- LX, SE, Sony Limited Edition, SVT, ZTS, ZTW, ZX3, ZX5 | 4 Cyl 2.0 L GAS, 4 Cyl 2.3 L GAS

2003 Ford Focus Blend Door Actuator

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2003 Ford Focus Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2003 Ford Focus Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2003 Ford Focus Blend Door Actuator Parts Q&A

Q: How to service the air inlet blend door actuator on 2003 Ford Focus?
A: In order to service, the air inlet blend door actuator, unhook the glove compartment and open it. Disconnect the screws and the plugs to remove the air recirculation flap servo motor. Make sure that the servo motor rests properly on the shaft and then assemble all the parts again and verify that the air recirculation flap is working.