OEM 2003 Ford Windstar ABS Control Module

2003 Ford Windstar ABS Control Module Parts Questions & Experts Answers

• Q: How to service and repair the ABS Control Module on 2003 Ford Windstar?

  A: Before uninstalling the Electronic Brake Control Module download its configuration data to the scan tool that will be required later for programming the new module installation. Challenge the battery ground wire while adjusting the vehicle in the air. Users should remove the Hydraulic Control Unit (HCU) dust shield through bolt and screw removal. The anti-lock brake control module electrical connector requires disconnection through a backward motion of its connector lock. Users must loosen the three HCU bracket to frame bolts followed by hooking the bracket out from the frame to lower the HCU for accessing the anti-lock brake module. The HCU components stay protected when lifting upward for bolt removal of the anti-lock brake module. Use the new module to receive configuration information that you transfer from the scan tool. The vehicle must drive a minimum of 16 km (10 miles) after battery disconnection and reconnection because the learning process for adaptive strategies causes temporary abnormal drive symptoms. Before placing the new module on the HCU top surface you must first clean that area before inspecting that both connector sides remain clean. Apply Silicone Brake Caliper Grease with Dielectric Compound D7AZ-19A331-A (WA-10) which adheres to Ford specification ESE-M1C171-A to the weather seal gasket. The restore method of removal should be applied to achieve installation completion.