OEM 2003 Lincoln Aviator Power Window Motor

2003 Lincoln Aviator Power Window Motor Parts Questions & Experts Answers

• Q: How to initialize the LF Power Window Motor on 2003 Lincoln Aviator?

  A: The initialization process for the LF door window motor requires a systematic check for any potential system obstacles. During shipping the LF window motor operates in error mode because initialization procedure is required to initiate functioning. The initialization process of the motor must occur after every time it leaves the window regulator drum housing and with each new motor or window regulator installation or new window glass update or application of lubrication to the window system. All LF windows need to have their glass and regulator along with their motor and glass top run properly installed at the specified tightening point before initiating the procedure. A partial completion of the procedure keeps the LF window motor uninitialized in its current state with proportional up/down capabilities. Start the procedure by placing the ignition key in OFF position while keeping the LF door open. Press six times on the front window control switch (LF) to the AUTO position while having the ignition key set to ON. Maintain the LF door open and turn the ignition key to OFF followed by pressing the front window control switch (LF) to AUTO position for six successive cycles. The LF door must be shut with the ignition in ON position which reveals a downward and upward movement of LF window glass by approximately 2-3 mm (0.1 in) to signal initialization mode entry. You should maintain pressure on the front window control switch (LF) to move it to the UP position when the glass reaches the upper header seal. Apply brief pressure to the front window control switch (LF) until it reaches the DOWN position for one-touch down operation and movement until it stops at the travel limit. Hold the front window control switch (LF) in an upward position until the glass stalls against the upper header seal while finishing down-up moves as a success indicator for initialization. The LF window must operate correctly during testing of its one-touch down and one-touch up modes and proportional down and up features; perform the audit again if the system fails to function correctly.