FordParts
My Garage
My Account
Cart
OEM 2006 Ford Crown Victoria Ignition Switch
Starter Ignition Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Ignition Switch found
2006 Ford Crown Victoria Ignition Switch Part Number: 5W1Z-11572-AA
$41.23 MSRP: $65.47You Save: $24.24 (38%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Switch Assembly - Ignition
- Base No.: 11572
- Item Weight: 0.40 Pounds
- Item Dimensions: 6.2 x 4.0 x 4.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5W1Z-11572-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Crown Victoria Ignition Switch
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford Crown Victoria Ignition Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford Crown Victoria Ignition Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford Crown Victoria Ignition Switch Parts Q&A
- Q: How to service and repair the ignition switch on 2006 Ford Crown Victoria?A: Service and repair operations on the ignition switch need to start by depowering the supplemental restraint system (SRS). Start by placing the ignition switch lock cylinder at RUN and use a suitable tool to push upward on the release tab which allows you to pull the cylinder outward. First unlatch and remove the tilt lever from the steering wheel before pushing the upper steering column shroud sides to release it. The upper and lower steering column shrouds need their three screws removed but reinstallation must follow with screw tightening to 2 Nm (18 inch lbs.). Disconnect the ignition switch electrical connector before removing its screw to extract the switch while torquing it to 5 Nm (44 inch lbs.) during installation. The SRS repowering process should start with a reversal of the removal sequence.