FordParts
My Garage
My Account
Cart
OEM 2006 Ford Fusion Power Steering Reservoir
Power Steering Fluid Reservoir Tank- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Power Steering Reservoirs found
Product Specifications- Other Name: Reservoir Assembly; Power Steering Reservoir; Reservoir
- Base No.: 3A697
- Item Weight: 4.40 Pounds
- Item Dimensions: 8.4 x 7.8 x 6.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7H6Z-3E764-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Reservoir Assembly; Power Steering Reservoir; Reservoir
- Base No.: 3A697
- Item Weight: 0.90 Pounds
- Item Dimensions: 8.2 x 5.0 x 3.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-3A697-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Fusion Power Steering Reservoir
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford Fusion Power Steering Reservoir available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford Fusion Power Steering Reservoir as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford Fusion Power Steering Reservoir Parts Q&A
- Q: How to Service and Repair the Power Steering Reservoir for the 2.3L Power Steering Pump on 2006 Ford Fusion?A: The process of servicing and repairing the power steering reservoir requires siphoning out power steering fluid through a suitable suction device from the 2.3L power steering pump reservoir. Afterward, you need to detach the accessory drive belt. Detach the clamp before removing the power steering return hose from the reservoir and disconnecting its pressure switch electrical connector. Melt the power steering pressure line banjo bolt before pulling out the line from the pump and getting rid of everything including the bolt and two seals. You should install the new banjo bolt with 35 Nm (26 ft. lbs.) torque. Match the three power steering pump bolts with new ones before installing the pump by tightening new bolts to 24 Nm (18 ft. lbs). The power steering pressure line must be disconnected from the pump only when you install a new bolt along with new seals. In conclusion, the procedure by filling the power steering system.