FordParts
My Garage
My Account
Cart
OEM 2006 Mercury Montego Blend Door Actuator
Air Blend Door Actuator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Blend Door Actuators found
2006 Mercury Montego Door Actuator Part Number: 5F9Z-19E616-GA
Product Specifications- Other Name: Motor Assembly; HVAC Blend Door Actuator; HVAC Heater Blend Door Actuator; Motor
- Base No.: 19E616A
- Item Weight: 0.60 Pounds
- Item Dimensions: 4.3 x 3.3 x 4.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5F9Z-19E616-GA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Mercury Montego Vacuum Motor, Rear Part Number: 8F9Z-19E616-A
Product Specifications- Other Name: Motor Assembly; HVAC Floor Mode Door Actuator; Lower, Rear, Air Inlet, Blower, Heater Blend Actuators; Actuator; Blower Motor
- Manufacturer Note: Air Distribution Mode Door
- Position: Rear
- Replaces: 5F9Z-19E616-CB, 5F9Z-19E616-AA
- Base No.: 19E616A
- Item Weight: 0.50 Pounds
- Item Dimensions: 4.7 x 1.6 x 4.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8F9Z-19E616-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Mercury Montego Blend Door Actuator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Mercury Montego Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Mercury Montego Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Mercury Montego Blend Door Actuator Parts Q&A
- Q: How to service the LH temperature blend door actuator on 2006 Mercury Montego?A: The LH temperature blend door actuator can be serviced by accessing it from below the LH side of the instrument panel. Start by removing the three screws fastening the actuator to place. The actuator needs to be disconnected from its electrical connector followed by removal from the mounting location. The installation process for the new actuator requires the exact opposite steps which were used for removal.