FordParts
My Garage
My Account
Cart
OEM 2007 Ford Crown Victoria Automatic Transmission Filter
AT Filter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Automatic Transmission Filter found
2007 Ford Crown Victoria Filter Part Number: F6AZ-7A098-A
$40.76 MSRP: $64.73You Save: $23.97 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Filter Assembly; Transmission Oil Filter; Transmission Filter; Screen
- Replaces: F4TZ-7A098-A
- Base No.: 7A098
- Item Weight: 4.10 Pounds
- Item Dimensions: 15.2 x 11.0 x 0.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F6AZ-7A098-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Crown Victoria Automatic Transmission Filter
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Crown Victoria Automatic Transmission Filter available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Crown Victoria Automatic Transmission Filter as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Crown Victoria Automatic Transmission Filter Parts Q&A
- Q: How to Service and Repair the Automatic Transmission Filter on 2007 Ford Crown Victoria?A: You should begin automatic transmission filter maintenance by excluding supplemental transmission fluid additives and cleaning agents because they might cause internal transmission component failure. The automatic transmission fluid needs regular replacement during normal maintenance while major repairs including clutch work and band and bearing replacements need transmission removal for proper execution. Operate vehicle maintenance procedures only when the primary fire suppression system of the vehicle is depowered. Before bolt removal from the transmission fluid pan begin draining the transmission fluid by putting the vehicle into neutral position and placing it on the hoist. The maintenance begins by removing the transmission fluid pan with its gasket before evenly sliding the filter and seal down to extract them from the fluid pathway. Thoroughly clean all parts of the transmission fluid pan and gasket before carefully inspecting the magnet. The procedure requires installation of a new filter while using a small screwdriver to remove excess seal from the main control bore with great caution to avoid damaging the bore. The filter can stay in service after inspection when the amount of contamination does not exceed stated limits but replacement of the filter as well as the seal is necessary for contamination-related failures. Install a new fluid filter followed by its specified seal then position the pan magnet into the transmission fluid pan and install the reusable gasket after cleaning it for any damage detection. The framework for the transmission fluid pan must be correctly positioned while the gasket gets installed before tightening pan bolts to 14 Nm (10 lb-ft). Repower the fire suppression system following installation in vehicles that have such systems. Use clean automatic transmission fluid to fill the transmission until it reaches its proper level. The amount required is 4.7L (5 qt).