How to remove and replace the rear footwell air duct on 2007 Lincoln Town Car?

Removing the front seats and the right-hand lower A-pillar trim panel are the first steps in order to remove the rear footwell duct. Then, take out the right-hand front safety belt anchor bolt and the right-hand low B-pillar finish panel. Loose the harness and take out the duct. Invert the process to fit in the new duct.

OEM 2007 Lincoln Town Car Air Duct

Air Hose

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Air Duct found

View related parts
2007 Lincoln Town Car Air Outlet Tube Part Number: 5W1Z-9B659-BE
Product Specifications
- Other Name: Hose - Air; Engine Air Intake Hose; Outlet Tube
- Manufacturer Note: Without internal hydrocarbon trap(not serviced)., FROM 11-29-04
- Base No.: 9B659
- Item Weight: 3.80 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5W1Z-9B659-BE
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Lincoln Town Car Submodels:
- Designer Series, Executive, Executive L, Protection Series, Signature, Signature L, Signature Limited | 8 Cyl 4.6 L FLEX, 8 Cyl 4.6 L GAS

2007 Lincoln Town Car Air Duct

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Lincoln Town Car Air Duct available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Lincoln Town Car Air Duct as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Lincoln Town Car Air Duct Parts Q&A

Q: How to remove and replace the rear footwell air duct on 2007 Lincoln Town Car?
A: Removing the front seats and the right-hand lower A-pillar trim panel are the first steps in order to remove the rear footwell duct. Then, take out the right-hand front safety belt anchor bolt and the right-hand low B-pillar finish panel. Loose the harness and take out the duct. Invert the process to fit in the new duct.