FordParts
My Garage
My Account
Cart
OEM 2007 Mercury Montego ABS Control Module
Anti Lock Brake Control Module- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 ABS Control Modules found
2007 Mercury Montego Control Module Part Number: 6F9Z-2C219-C
Product Specifications- Other Name: Control; ABS Control Module
- Base No.: 2C219
- Item Weight: 1.40 Pounds
- Item Dimensions: 13.4 x 10.4 x 5.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-2C219-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Mercury Montego Control Module Part Number: 6F9Z-2C219-B
Product Specifications- Other Name: Control; ABS Control Module
- Replaces: 5F9Z-2C219-DA
- Base No.: 2C219
- Item Weight: 1.70 Pounds
- Item Dimensions: 13.7 x 10.5 x 5.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-2C219-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Mercury Montego Control Module Part Number: 6F9Z-2C219-A
Product Specifications- Other Name: Control; ABS Control Module
- Base No.: 2C219
- Item Weight: 1.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-2C219-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Mercury Montego ABS Control Module
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Mercury Montego ABS Control Module available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Mercury Montego ABS Control Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Mercury Montego ABS Control Module Parts Q&A
- Q: What Are the Steps and Precautions for Handling and Installing the ABS Control Module on 2007 Mercury Montego?A: The Electronic Brake Control Module with the Anti-Lock Brake System (ABS) Module needs proper treatment because its electrical charge sensitivity leads to module damage when exposed. Installing a new ABS module requires a calibration process that needs vehicle-as-built data through scan tool directions as part of the configuration procedure. First remove the HCU before unparking the four ABS module securing screws. During the installation process tighten the screws to 3 Nm (27 lb-in) then carry out the reverse removal steps to finish installing the hardware.