FordParts
My Garage
My Account
Cart
OEM 2007 Mercury Monterey Ignition Coil
Ignition Coil Resistor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Ignition Coil found
2007 Mercury Monterey Ignition Coil Part Number: 5F2Z-12029-AD
$79.89 MSRP: $131.45You Save: $51.56 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Coil Assembly - Ignition; Direct Ignition Coil Oe Quality; Direct Ignition Coil; Coil
- Replaces: 1F2Z-12029-AC
- Base No.: 12029
- Item Weight: 2.30 Pounds
- Item Dimensions: 8.5 x 4.6 x 4.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5F2Z-12029-AD
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Mercury Monterey Ignition Coil
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Mercury Monterey Ignition Coil available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Mercury Monterey Ignition Coil as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Mercury Monterey Ignition Coil Parts Q&A
- Q: How to service and repair the ignition coil on 2007 Mercury Monterey?A: Service work and repairs on the ignition coil begin by disconnecting the ground cable of the battery. Begin by taking out the cowl panel grille then disconnect the windshield wiper motor electrical connector. Remove the bolts for the cowl lower panel before reinstalling them tightly at 6 Nm (53 lb-in). Start by disconnecting the ignition coil electrical connector then twist each spark plug wire boot before pulling it upwards as a protection method against wire damage. Lastly check the wire positions to match the correct ignition coil terminal. Detach the six spark plug wires from the ignition coil before you remove its securing bolts which need to be tightened to 7 Nm (62 lb-in) after installation. The installation should end by following the reverse steps of the removal process.