How to Service the Rear Door Check for the SuperCab on 2008 Ford Ranger?

Service of the rear door check of the SuperCab requires one to remove rear door trim panel, followed by the removal of the rear door check arm-to-body bolt (tighten to 25 Nm) and the door check arm-to-door nut (tighten to 9 Nm) on both sides. Installation is done by inverting the steps undertaken to remove the part.

OEM 2008 Ford Ranger Door Check

Front Door Check Strap

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Door Check found

View related parts
2008 Ford Ranger Door Check, Rear Part Number: F87Z-1327204-AA
$38.85 MSRP: $53.74
You Save: $14.89 (28%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Check Assembly - Door; Door Check, Rear
- Position: Rear
- Base No.: 27204
- Item Weight: 1.00 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F87Z-1327204-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2008 Ford Ranger Submodels:
- Edge, FX4, Splash, Sport, STX, Tremor, XL, XLT | 4 Cyl 2.3 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 4.0 L GAS

2008 Ford Ranger Door Check

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Ranger Door Check available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Ranger Door Check as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2008 Ford Ranger Door Check Parts Q&A

Q: How to Service the Rear Door Check for the SuperCab on 2008 Ford Ranger?
A: Service of the rear door check of the SuperCab requires one to remove rear door trim panel, followed by the removal of the rear door check arm-to-body bolt (tighten to 25 Nm) and the door check arm-to-door nut (tighten to 9 Nm) on both sides. Installation is done by inverting the steps undertaken to remove the part.