FordParts
My Garage
My Account
Cart
OEM 2009 Ford Crown Victoria Blend Door Actuator
Air Blend Door Actuator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Blend Door Actuators found
2009 Ford Crown Victoria Door Actuator Part Number: XW7Z-19E616-BA
$47.22 MSRP: $76.18You Save: $28.96 (39%)Product Specifications- Other Name: Motor Assembly; HVAC Air Inlet Door Actuator; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Actuator Assembly
- Replaces: F8VZ-19E616-BA
- Base No.: 19E616
- Item Weight: 0.60 Pounds
- Item Dimensions: 8.4 x 7.7 x 7.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW7Z-19E616-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Crown Victoria Door Actuator Part Number: AW7Z-19E616-A
$50.95 MSRP: $80.91You Save: $29.96 (38%)Product Specifications- Other Name: Motor Assembly; HVAC Air Inlet Door Actuator; HVAC Heater Blend Door Actuator; Actuator Assembly
- Replaces: 1W7Z-19E616-AA, XW7Z-19E616-AA
- Base No.: 19E616
- Item Weight: 0.60 Pounds
- Item Dimensions: 8.5 x 7.7 x 7.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: AW7Z-19E616-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Crown Victoria Blend Door Actuator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Crown Victoria Blend Door Actuator available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Crown Victoria Blend Door Actuator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Crown Victoria Blend Door Actuator Parts Q&A
- Q: How to Service and Repair the Front Blend Door Actuator for the Floor Defrost Door on 2009 Ford Crown Victoria?A: Service and repair of the floor defrost door vacuum control motor starts with clearing the LH lower instrument panel insulator then removing the two pin-type retainers and trim panel. Move forward with the two screw removal of the Data Link Connector (DLC) while also detaching the vacuum line. The service requires LCM Lighting Control Module extraction through unfastening its screws and releasing the clip before disconnecting all electrical connectors. The LCM bracket requires screw removal along with the LCM bracket until the floor/defrost door vacuum control motor can be extracted by separating its clip and two nuts. The last step requires removing the vacuum connectors that connect to the floor/defrost door vacuum control motor. Install the new components by carrying out the steps performed when removing these parts.