How to Service the LH Halfshaft Wheel Seal on the 6F50 on 2009 Ford Taurus?

When servicing LH halfshaft seal on the 6F50, make sure that vehicle is in neutral position on a hoist. Take off and check the halfshaft. Make a hole in the seal, pull it off and use a seal installer to replace it. Install the halfshaft again and add fluid to the transmission.

OEM 2009 Ford Taurus Wheel Seal

Wheel Axle Seal

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Wheel Seal found

View related parts
2009 Ford Taurus Axle Seal, Rear Driver Side Part Number: 5L8Z-4B416-AA
$14.61 MSRP: $21.27
You Save: $6.66 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Seal; Drive Axle Shaft Seal, Front Left; Rear; CV Axle Shaft Seal, Front; Left; Rear.; Axle Seals; Side Seal; Outer Seal; Inner Joint Assembly Seal; Drive Axle Shaft Seal
- Manufacturer Note: 58mm
- Position: Rear Driver Side
- Replaces: F57Z-3254-BA
- Base No.: 4B416
- Item Weight: 0.40 Pounds
- Item Dimensions: 4.2 x 4.1 x 4.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5L8Z-4B416-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2009 Ford Taurus Submodels:
- Limited, SE, SEL, SHO | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS

2009 Ford Taurus Wheel Seal

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Taurus Wheel Seal available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Taurus Wheel Seal as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2009 Ford Taurus Wheel Seal Parts Q&A

Q: How to Service the LH Halfshaft Wheel Seal on the 6F50 on 2009 Ford Taurus?
A: When servicing LH halfshaft seal on the 6F50, make sure that vehicle is in neutral position on a hoist. Take off and check the halfshaft. Make a hole in the seal, pull it off and use a seal installer to replace it. Install the halfshaft again and add fluid to the transmission.