FordParts
My Garage
My Account
Cart
OEM 2009 Ford Taurus X Trunk Lid Lift Support
Lift Strut Rod- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Trunk Lid Lift Supports found
2009 Ford Taurus X Lift Cylinder, Rear Passenger Side Part Number: 6F9Z-74406A10-B
$33.31 MSRP: $45.33You Save: $12.02 (27%)Product Specifications- Other Name: Lift Assembly - Gas; Liftgate Lift Support, Rear Right; Back Glass Lift Support; Door Lift Support; Support Cylinder; Liftgate Lift Support; Lift Support
- Position: Rear Passenger Side
- Base No.: 74406A10
- Item Weight: 1.60 Pounds
- Item Dimensions: 26.7 x 2.9 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-74406A10-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
- Product Specifications
- Other Name: Lift Assembly - Gas; Liftgate Lift Support, Rear Left; Back Glass Lift Support; Door Lift Support; Support Cylinder; Liftgate Lift Support; Lift Support
- Position: Rear Driver Side
- Base No.: <406A10
- Item Weight: 1.20 Pounds
- Item Dimensions: 26.7 x 2.9 x 2.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6F9Z-74406A11-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Taurus X Trunk Lid Lift Support
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Taurus X Trunk Lid Lift Support available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Taurus X Trunk Lid Lift Support as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Taurus X Trunk Lid Lift Support Parts Q&A
- Q: How to service and repair the Trunk Lid Lift Support on 2009 Ford Taurus X?A: A service repair of the power liftgate rod requires the removal of the LH quarter trim panel access cover. Press the clip on the power liftgate rod to disengage it from the motor assembly then raise the rod assembly while freeing it away. The service team must remove the cover along with its retaining nut while using threadlock to treat all fastener threads before securing it at 11 Nm (97 lb-in). You must take out the three power liftgate rod mounting bracket nuts before installation although you should securely tighten them to 30 Nm (22 lb-ft). To install and activate the power liftgate execute the opposite instructions of the removal sequence.