How to Service the Fuel Pump Driver Module on 2009 Lincoln MKS?

To service the Fuel Pump Driver Module, the backrest on the rear seat should be taken off and the electrical connector should be disconnected. Removal should not be over tightened. Installation should be done by removing the 2 nuts and adjusting them to 5 Nm (44 lb-in) tightness. Lastly, undo the procedure to remove to finish the process.

OEM 2009 Lincoln MKS Fuel Pump Driver Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Driver Module found

View related parts
2009 Lincoln MKS Fuel Pump Relay Part Number: GA8Z-9D370-A
$68.24 MSRP: $132.44
You Save: $64.20 (49%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Control Unit; Fuel Pump Driver Module; Multi Purpose Relay; Fuel Pump Controller; Relay; Module
- Replaces: 8U5Z-9345-C, 8U5Z-9345-D, AA8Z-9345-A, AA8Z-9D370-D, AA8Z-9D370-B, AA8Z-9D370-A
- Item Weight: 0.60 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: GA8Z-9D370-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2009 Lincoln MKS Submodels:
- Base, EcoBoost | 6 Cyl 3.5 L GAS, 6 Cyl 3.7 L GAS

2009 Lincoln MKS Fuel Pump Driver Module

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Lincoln MKS Fuel Pump Driver Module available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Lincoln MKS Fuel Pump Driver Module as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2009 Lincoln MKS Fuel Pump Driver Module Parts Q&A

Q: How to Service the Fuel Pump Driver Module on 2009 Lincoln MKS?
A: To service the Fuel Pump Driver Module, the backrest on the rear seat should be taken off and the electrical connector should be disconnected. Removal should not be over tightened. Installation should be done by removing the 2 nuts and adjusting them to 5 Nm (44 lb-in) tightness. Lastly, undo the procedure to remove to finish the process.