OEM 2009 Lincoln Navigator Wiper Motor

2009 Lincoln Navigator Wiper Motor Parts Questions & Experts Answers

• Q: How to service the rear window wiper motor on 2009 Lincoln Navigator?

  A: You must first remove the rear wiper pivot arm combined with the dust boot cover before servicing the rear window wiper motor. Start by removing the nut inside together with the rear window glass handle. Then open the liftgate glass before you continue. Begin by removing the nuts from the rear window striker as well as wiper pivot shaft assembly before removing the liftgate trim panel. Customers should first close the liftgate and access the liftgate window glass latch if planning to install a new rear wiper motor. First disconnect the electrical connector before removing the bolts which enable removal of the rear window wiper motor. The first step for installation is to install the liftgate window glass latch followed by tightening its bolts to 8 Nm (71 lb-in) while ensuring the striker engages the latch audibly. The rear window wiper striker and pivot shaft assembly requires alignment with the wiper motor through use of a provided alignment tool to achieve correct fitting and reach secure attachment. Fasten the rear wiper motor with bolts at 11 Nm (97 lb-in) torque before connecting all electric wires. After closing the liftgate glass properly you should open it to install the rear window wiper striker and wiper pivot arm mounting assembly nuts before tightening them to 6 Nm (53 lb-in). Secure the rear window glass handle and its nut by torquing it to 18 Nm (159 lb-in) then put back the dust boot cover and rear wiper pivot arm. Begin by opening the liftgate and then removing two tools followed by opening the liftgate glass before final installation of the liftgate trim panel. Normal operation of the liftgate and liftgate glass should be tested.