OEM 2009 Mercury Milan Battery Cable

2009 Mercury Milan Battery Cable Parts Questions & Experts Answers

• Q: How to service the battery cables on a 2.3L engine on 2009 Mercury Milan?

  A: Start cable battery service on a 2.3L engine vehicle by placing it in NEUTRAL position on a hoist. The battery disconnect process should start with a battery removal followed by nut and bolt and bracket removal before tightening the battery connection to 10 Nm (89 lb-in). The battery cable body ground terminal can be detached by removing its bolt while you tighten it to 12 Nm (106 lb-in) when reinstalling. Reinstall the Battery Junction Box (BJB) cable terminal after positioning it above the nut. Tighten this connection to 8 Nm (71 lb-in). Free the two battery cable locators at the battery tray until you remove the bolt which you will install the battery cable transaxle ground terminal before tightening it to 10 Nm (89 lb-in). Remove the starter solenoid terminal cover before removing its nut to position the battery cable starter solenoid terminal aside. The final action upon rebuild is tightening it to 12 Nm (106 lb-in). The starter stud bolt covers must be freed from the locator before users extract the three locator pieces from engine rear positions. Repair the replacement generator shield by inserting two nuts which need to be tightened to 25 Nm (18 lb-ft). After setting the generator protective cover to the side users need to remove the nut and place the generator B+ terminal in position while tightening it to 12 Nm (106 lb-in). The process ends with battery cable removal before reinstalling all components in the opposite order.