OEM Ford Contour Exterior Door Handle

Ford Contour Exterior Door Handle Parts and Q&A

• Handle, Outside, Passenger Side
  F5RZ5422404CC
  Q: How to service and repair the front exterior door handle on Ford Contour?

  A:

  Start the repair of the front door exterior handle by removing the ground cable from the battery. You should peel back the door watershield using a plastic knife to cut the Butyl strip yet maintain contact with the adhesive surface free of direct touch as this damages re-bonding. Hold the latch remote control illumination lamp electrical connectors at their two ends to remove the control through unscrewing the screws and carefully prying the handle housing from its place. Start by removing the outer door handle bezel after disconnecting electrical connectors and detaching wiring harness. Then remove the latch screws before you can take out the bolts. Drill the handle and latch assembly out from the door while disconnecting the actuator electrical connector and taking out the latch actuating rod by prying the retaining clip. To begin disconnection of the door handle start by moving the two rubber lugs towards each other while removing the handle from its holes. A 90-degree rotation of the door handle enables you to remove the actuator rod from the latch lever. The illumination wiring must be detached first before disconnecting the entry illumination switch and lock barrel illumination electrical connectors to allow removal of the barrel using a clip prying tool and barrel push-out method. Disconnect the actuator rods that are present in the handle. To install the unit follow the uninstallation steps in reverse while making sure drive square and barrel grooves correctly match handle bracket and operating lever before reapplying the retaining clip.
• Handle, Outside, Outer Driver Side
  F5RZ5426605AA
  Q: How to service the Rear Exterior Door Handle on Ford Contour?

  A:

  The service of the rear door exterior handle starts by disconnecting the ground cable from the battery. The door service starts by removing the rear door trim panel along with its door speaker followed by detaching the door watershield by gently cutting through the Butyl strip using a plastic knife to sustain the adhesive surface integrity. The actuator rod needs careful detachment using clip open levering at its lower section followed by lifting the handle to detach the upper section. detach the bezel retaining nuts and the nut cover followed by removing the handle as well as the bezel assembly. The process of installation involves reversing the removal steps with particular attention to hooking the actuator rod into the handle when it is in its open position.