How to Properly Maintain the Throttle Position Sensor in a Lincoln Aviator?

The service operation for throttle position (TP) sensor starts with disconnecting the battery ground cable followed by removing the TP sensor electrical connector. Proceed to remove the TP sensor retaining screws while making sure to tighten them to 10 Nm (89 lb-in) during the installation phase. Resume the procedure by installing the new or repaired sensor after removing the TP sensor.

OEM Lincoln Aviator Throttle Position Sensor

TPS Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Throttle Position Sensor found

View related parts
Lincoln Aviator Throttle Position Sensor
Part Number: F4SZ-9B989-AA
$49.93 MSRP: $82.16
You Save: $32.23 (40%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Potentiometer - Engine Throttle; Throttle Pos Sensor; Fuel Injector; Throttle Sensor; Potentiometer; Injector
- Replaces: F4SZ-9B989-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2005 Lincoln Aviator | Base | 8 Cyl 4.6 L GAS

Lincoln Aviator Throttle Position Sensor

Welcome to our website where you can discover high-quality, genuine Lincoln Aviator Throttle Position Sensor. We offer an extensive inventory of OEM Lincoln Aviator Throttle Position Sensor at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.

Lincoln Aviator Throttle Position Sensor Parts Questions & Experts Answers

Throttle Position Sensor
F4SZ-9B989-AA
Q: How to Properly Maintain the Throttle Position Sensor in a Lincoln Aviator?
A: The service operation for throttle position (TP) sensor starts with disconnecting the battery ground cable followed by removing the TP sensor electrical connector. Proceed to remove the TP sensor retaining screws while making sure to tighten them to 10 Nm (89 lb-in) during the installation phase. Resume the procedure by installing the new or repaired sensor after removing the TP sensor.