OEM Lincoln Mark LT Bumper Cover

Lincoln Mark LT Bumper Cover Parts and Q&A

• Bumper Cover, Front
  6L3Z-17D957-BAPTM
  Q: How to remove and replace the front bumper cover on Lincoln Mark LT?

  A:

  The first step for removing and installing the front bumper cover involves headlights removal. The reinstallation process requires new bolts to replace the ones connecting the front bumper cover with the front bumper. The first set of steps includes removing hood over-slam bumper bolts as well as bumper bolts before moving onto front bumper cover brace bolts and braces. You should remove both the front bumper cover-to-front fender bolts and the pin-type retainers from the system. Vehicle owners should extract retaining nuts from four locations while also unfastening the four fender splash shield screws then disconnect six clips before removing pin-type retainers along with four retaining nuts and four fender splash shield screws to isolate wheelhouse lip mouldings. The installation process ends by removing the bumper cover bolts present at the headlamp openings followed by disconnecting the front bumper cover. Reinstallation of the new cover requires following the same steps backwards.
• Bumper Cover, Front
  4L3Z-17D957-DA
  Q: How to service and repair the front bumper cover on Lincoln Mark LT?

  A:

  The first step of servicing and repairing the front bumper cover requires removing the headlamps from early and late Mark LT vehicles alongside all F150 vehicles. The next step involves removing the front bumper cover-to-front bumper bolts after which you should detach the hood over-slam bumper bolts and hood over-slam bumpers. Both the front bumper cover brace bolts and front bumper cover braces need to be taken out according to the sequence. The next step requires the removal of the front bumper cover-to-front fender bolts alongside the front bumper cover pin-type retainers. The installation process of wheelhouse lip mouldings requires disconnecting four retaining nuts in addition to fender splash shield pin-type retainers and four fender splash shield screws before placing them carefully to the side. You will disconnect six clips that hold the wheelhouse lip moulding before releasing all retaining clips. All vehicles require removal of the bumper cover bolts which are positioned near the headlamp opening before removing the front bumper cover. The installation of the new cover must follow the steps used for removal in reverse order.