OEM Mercury Marauder Bumper Cover

Mercury Marauder Bumper Cover Parts and Q&A

• Bumper Cover
  3W3Z-17D957-AAA
  Q: How to remove and install the front bumper cover on all on Mercury Marauder?

  A:

  The process to replace the front bumper cover demands that the vehicle gets lifted while receiving support for all vehicle models. The illustration presents the right-hand side while both the left-hand and right-hand sides share the same structure on this part of the operation. You should start by removing the six bolts from the lower radiator air deflector then dislag the two front bumper cover bolts and the two pin-type retainers. Begin by eliminating all six pin-type retainers that exist in three separate groups on both sides of the component. Disconnect both fog lamp electrical connectors on the Marauder. The vehicle needs to be lowered first before you remove the headlamps and two screws from the front bumper cover on both sides plus the two screws underneath. Removing the four tabs completes the process of removing the front bumper cover. After reversing the removal steps, you can install the system by placing necessary parts back in place.
• Bumper Cover
  3W3Z-17K835-AAA
  Q: How to service the rear bumper cover on Mercury Marauder?

  A:

  The service process for rear bumper cover begins with correctly supporting the vehicle in a raised position. You need to begin by removing rear bumper cover screws and proceeding with taking out six pin-type retainers which are split between three on either side. Each side contains three screws for the rear bumper cover which needs to be removed followed by lower the vehicle. Unfasten the pin-type retainers from the luggage compartment rear trim panel along with the luggage compartment lining material placed to the side. First detach the four nuts on each rear side of the bumper cover before pulling out the six other nuts located on either side to disconnect the rear bumper cover. Simply execute the very opposite steps to reinstall the new cover.