Ford 1S8Z19980AA
Temperature Control

The blower motor switch service requires removal of first the audio unit then the floor console along with the switch assembly. Disconnect both electrical connectors from the switch assembly before separating it from its housing. The first step for heater control/audio unit bezel detachment involves unscrewing the panel but following it with clip release to remove the unit from its position. The next step involves the removal of the heater control/audio unit bezel followed by electrical connector detachment and vacuum line unattachment. Next in order is the removal of the heater control panel with subsequent removal of the blower motor switch. Installation happens through performing the complete opposite method of removal.

Service of the blower motor switch starts with removing the audio unit then the floor console and switch assembly before detaching the switch assembly and disconnecting electrical connectors. The move to detach the heater control/audio unit bezel starts with unscrewing its fasteners followed by unclipping the panel from its attachment points. First detach the electrical connectors from the heater control/audio unit bezel before removing it and cutting the vacuum lines. Uninstall the heater control panel followed by the blower motor switch from the system. The reversal of these steps should be followed for installing the components.

Remove the climate control panel.

Reverse the removal procedure.

Remove the screws and pull the panel from the clips.