Ford 7L5Z-10043B13-AB
Inflator Module

Remove all potential risk for serious personal injury by facing air bag modules away from your body when transporting driver air bags and placing them on the surface with deployment doors and trim covers and tear seams facing upward. Probing the electrical connectors of air bag and Safety Canopy(R) along with side air curtain modules will cause accidental deployment which creates a severe risk of deadly injuries. All air bag module trim covers together with deployment doors need to stay unpainted since paint can lead to improper deployment sequences. Visual warnings will appear on the air bag indicators if the proper Restraints Control Module (RCM) fuse is unplugged while the engine operates with ON conditions until all Supplemental Restraint System (SRS) functions work correctly before vehicle delivery to customers. Begin by depowering the SRS. Detach the two driver air bag module bolts while you disconnect the electrical connectors through an upward lift of locking buttons without using the buttons to extract them since this could damage them. The installation of electrical connectors into the driver air bag module requires full insertion with correct positioning of locking buttons. Position the driver air bag module back in its place then fasten it by using two bolts which need a torque of 6 Nm (53 lb-in). Finally, repower the SRS.

Begin by depowering the system.

Always wear eye protection and avoid probing the electrical connectors on air bag, Safety Canopy®, or side air curtain modules to prevent accidental deployment, which can lead to serious injury or death.

Disconnect the passenger air bag module electrical connector and remove the two bolts securing the module.