Ford XW4Z-3A674-GBRM
Power Steering Pump

Start power steering pump repair by detaching four pushpins then the engine cover and proceeding with removing the air cleaner and the air cleaner outlet tube. The procedure starts with belt removal followed by unclamping the power steering reservoir-to-pump hose for draining into a suitable container. First position the vehicle on a hoist and then you need to remove both tire and wheel assembly. First disconnect the two bolts and pushpin and shield and then move on to discarding two more pushpins and another shield before removing the bolt and power steering pressure hose. Start to remove the next bolt after disconnecting the power steering pressure hose plus removing its bolt. After lowering the vehicle remove all pump-securing bolts. Fasten the power steering pressure hose fitting with a new O-ring while leaving the upper bolts untightened until all lower bolts have been installed. Raise the vehicle to install the bolt and power steering pressure hose after you reinstall both the pump and its bolts. First install another bolt after putting on the shield followed by its attachment to two pushpins before inserting the shield via one pushpin while securing it with two bolts. After installing the wheel time assembly users should lower the car before tightening every fastener. The next procedure involves the accessory drive belt then the air cleaner outlet tube followed by the air cleaner cover while examining pushpins for damage before replacing damaged ones. Reinstall the engine cover while using four pushpins and fill up the system and perform a leak test.

Place a new O-ring on the power steering pressure hose fitting, ensuring not to tighten the upper bolts until the lower bolts are installed.