Ford 6E5Z-8005-C
Radiator

The radiator servicing process starts with draining the cooling system from all vehicles. The first step requires removal of the cooling fan motor as well as shroud before proceeding to disconnect the power steering hose retainer from the radiator. Begin service by removing the upper radiator hose together with its retainer from the radiator then disconnect the radiator-to-degas bottle hose following. Disconnection of automatic transmission cooling tubes from the radiator requires 30 Nm tightness for reinstallation. After disconnecting the lower radiator hose from the radiator you should lift the tabs from the upper radiator support while placing the radiator in front of the engine. Detach the pushpin-type retainer linking the A/C condenser to the radiator before compressing the tabs and pulling the A/C condenser away from the radiator in order to remove the radiator. The new radiator installation requires the reverse of removal steps followed by completing the cooling system filling then bleeding process.

The radiator servicing requires draining the cooling system as a first step. The service procedure starts by removing the cooling fan components and following it up with detachment of power steering hose from the radiator. Start by removing the radiator-to-upper hose along with its retainer and then disconnect the degas bottle hose from the radiator. Automatic transmission vehicles require users to disconnect their two transmission cooling tubes from the radiator and then tightening each connection to a torque of 30 Nm (22 ft. lbs.) before reinstallation. Begin the process by removing the lower radiator hose followed by lifting out the tabs from the upper radiator support before moving the radiator in front of the engine. First disconnect the A/C condenser-to-radiator pushpin-type retainer before squeezing its tabs which will enable the A/C condenser separation from the radiator and subsequent radiator removal. The cooling system filling and bleeding operations must be performed after reversing the removal operations.

You must drain the cooling system at the start of radiator repair and service operations. Start by taking out the cooling fan motor together with its shroud followed by detaching the power steering hose retainer from the radiator. Dispense the upper radiator hose and free the retainer from the radiator before disconnecting the radiator-to-degas bottle hose. You should disconnect the two transmission cooling tubes from the radiator of automatic transmission vehicles followed by tightening them to 30 Nm (22 lb-ft) when reattaching them. Start the radiator lower hose detachment from the radiator then raise and remove upper radiator support tabs to position the radiator in front of the engine. The removal process starts with the A/C condenser-to-radiator pin-type retainer which should be separated and the tabs should be squeezed to detach the A/C condenser from the radiator before taking out the radiator. The new radiator installation requires following the reverse steps of removal with cooling system filling and bleeding.