Ford H2MZ-8005-AA
Radiator

Before starting radiator servicing you need to drain all cooling system liquid then discard the engine appearance cover along with the air cleaner outlet tube. Service individual components by following the exact step-by-step instructions which include reference to the provided illustrations and tables. The reverse installation steps must be applied to reassemble all removed parts. Replenish the cooling system and perform bleeding procedures after refilling it. To remove the automotive condenser you should lower it down in order to access the A/C condenser-to-radiator bolts. A forward-leaning angle of the radiator can be needed before removing combination coolers since their bolts are difficult to access. To install or remove the combination cooler you should raise it forward at an angle so it releases from the radiator retaining clips while ensuring complete insertion into those clips.

The radiator servicing and repairing process begins with placing the vehicle in NEUTRAL position on a hoist while draining the cooling system. Start by taking off the upper radiator sight shield followed by removing the upper and lower radiator hoses then setting them aside. Installation of these parts requires 10 Nm (89 inch lbs.) torque which should be used when re-attaching them. The service process starts with lowering the A/C condenser to reach the A/C condenser to radiator bolts then removing those two retaining bolts before setting the A/C condenser aside. Tighten these bolts during reinstallation to 10 Nm (89 inch lbs.). Fit new upper brackets to the A/C condenser along with the two bolts before tightening these fasteners to 10 Nm (89 inch lbs.). Position the radiator forward if needed to access the bolts before lifting the combination cooler towards the front to remove it from the retaining clips and then untighten the two bolts to set the cooler aside at 10 Nm (89 inch lbs.). Separate the three bolts before letting the radiator shield fall under gravity while releasing its retaining clips from position. Afterward, remove the radiator. Reverse the removal process by fitting the combination cooler into the retaining clips of the radiator and complete the installation by filling and bleeding the cooling system.

Disconnect them from the radiator and set them aside.

It may be necessary to lean the radiator forward for better access.

Remove the bolt that secures the receiver drier and position it aside.

Disconnect the return hose from the cooling fan and shroud, then separate the return hose from the fan shroud and set it aside.

Reverse the procedure for installation and make sure to fill and bleed the cooling system afterward.

Lift the combination cooler up and forward to release it from the radiator retaining clips, then remove the two bolts and set the combination cooler aside, tightening to 10 Nm (89 inch lbs.) when reinstalling.

Drain the cooling system, then remove the air cleaner outlet tube and the upper radiator sight shield.