Ford F5RZ-5423208-A
Window Regulator, Passenger Side

Service of the rear door window regulator starts from removing the door trim panel and door pull then unscrewing them all. The door speaker needs detachment by removing screws and disconnecting its multiplug. A plastic knife should be used to gently peel back the watershield while cutting through the Butyl strip in a way that prevents touching the adhesive surfaces to keep them bonded. The window retaining bolts need removal, while users should connect the power window operating switch electrical connector before they align the bolts with the access holes. Start by removing the ground cable from the battery then establish the glass at its full shut position while the ground cable remains disconnected. Users should detach the window regulator through removal of regulator assembly bolts followed by allowing the regulator to settle at the door bottom and then remove the regulator motor using either three bolts or the manual regulator winder method with two bolts which should also be placed at the bottom position. The electrical connector should be disconnected from the regulator motor while removing the window regulator and its mounting plate with both motor bushings. Reinstall the component by doing the reversed steps of removal.

Service and repair on the front door window regulator starts with you removing the door trim panel followed by detaching the door speaker through unscrewing its retaining screws. Disconnect the multiplug while you use a plastic knife to cut through the Butyl strip of the watershield. Trod here because touching the adhesive surface before service could disable future bonding integrity. Attach the window operating switch electrical connector and uninstall the window glass retaining bolts while maintaining their alignment to the access holes. Proceed with battery cable grounding while lifting the window glass completely shut. Remove the regulator assembly bolts before letting the assemblage drop to the door bottom. The regulator motor can be removed through three bolts for motors or two bolts for manual regulator winders and should then sit at the bottom of the door after separate installation. The regulator motor electrical connector must be detached before removal of the window regulator along with the motor mounting plate nut and the motor mounting bushes. The installation can be finished through the reverse order of the removal steps.

Service of the rear door window regulator starts by removing door trim panel and door pull through screw removal. Detaching the door speaker starts with unscrewing its fasteners followed by unplugging the multiplug. A plastic knife should be used to wedge open the watershield while slicing through the Butyl strip with precision to avoid damaging the adhesive for re-establishment. Place the window regulator handle into position before taking out the window retaining bolts while keeping them directly over the access holes. The glass should be in complete closure with support until regulator assembly bolt removal enables the assembly to stay at the doorway base. The regulator motor and manual regulator winder need to be taken out by removing three bolts or two bolts respectively to let the assembly sit at the bottom of the door. The window regulator handle and the window regulator must be taken away in the conclusion of this process. The end of installation calls for the opposite deployment process to be executed.