Ford F8RZ-6323209-AA
Window Regulator, Driver Side

Beginning the front door window regulator service requires removal of the door glass and disconnection of the door speaker before disconnecting the electrical connector. The detachment of watershield can be accomplished with a plastic blade that cuts through the Butyl strip while you must avoid contact with adhesive surfaces to maintain re-bonding properties. A better work position for the door speaker housing can be created by peeling the watershield beyond its boundaries. You should disconnect the regulator motor electrical connector before removing the regulator guide. Use a drill to remove the rivets before you can detach the regulator and the motor by taking out the nuts. To install the parts follow the reverse steps of the removal process.

The service process for front door window motor and regulator begins by taking out the door glass and separating the door speaker and removing the electrical connector. A plastic knife can be used to cut through the Butyl strip of the watershield yet care must be taken to not touch the adhesive side to protect its ability to re-bond. The watershield must be peeled back beyond the door speaker housing to get better access for service. First disconnect the regulator motor electrical connector before moving on to remove the regulator guide and separate the motor and regulator units through nuts removal and rivet drilling. The installation process demands the exact opposite of the removal steps.

Disconnect the regulator motor electrical connector, remove the regulator guide, and then detach the motor and regulator by removing the nuts and drilling out the rivets.