Ford 7T4Z-7827000-A
Window Regulator, Rear Passenger Side

The service of rear door window components begins with taking out the speaker unit from the door. Before cutting the window regulator cable it is important to support the window glass unless you plan to install a new window regulator assembly. Chose the window control switch as the first test to confirm that the window operates. After unplugging the access there you should lower the window glass and tape it in place before removing the glass clamp bolt. The regulator needs support before loosening the glass clamp bolt. When reinstalling tighten it to 9 Nm (80 lb-in). The technician should lower the regulator to its bottom position on the track stops before disconnecting the electrical slot at the B-pillar. Use the speaker hole for access to release the clip attaching the harness to your door by removing its two securing bolts from the electrical harness grommet. Guided by the weather strip you can unclip and insert the wiring harness into the opening between door weather strip and door. The three door latch screws need removal followed by tightening them to 9 lb-ft during reinstallation. Take out the access plug from the door latch side followed by unscrewing the outside door handle reinforcement screw then the handle itself. The screw should be secured to 8 Nm (71 lb-in) when reinstalling it. When installing the module rear door remove first the keypad from the door followed by removal of nine door module bolts after which you can take out the module moving its components then readjust the bolts to 9 Nm (80 lb-in) torque specification. You should perform the installation by reversing the removal steps.

Service of the rear door window regulator starts by removing its associated speaker component. The window regulator cable can only be cut during new window regulator assembly installation but you must support the window glass first if it fails to operate. Examine the function of the window by restoring connection of the control switch. After removing the access plug you must gradually lower the window until the clamp bolt becomes reachable through the glass opening which requires tape for securement. The regulator must be properly supported before unfastening the glass clamp bolt while tightening it to 9 Nm (80 lb-in) upon reinstalling. Lower the window regulator until it reaches the stops on the bottom of the regulator tracks before disconnecting the B-pillar electrical connector. Release the electrical harness by removing its clips through the speaker hole access point while removing the two bolts from the door grommet. After unclipping the weather strip users should guide the wiring harness through the space between the weather strip and door. You should first disconnect the door latch screws using 12 Nm (9 lb-ft) torque then re-tighten them during reinstall. Start by removing the access plug located on the door latch side and eliminating both the exterior door handle reinforcement screw and handle. Reinstall the screw afterward by tightening it to 8 Nm (71 lb-in). Follow the door keypad removal by removing the nine bolts of the door module while transferring replacement components before securing them with 9 Nm torque. Finish the installment by following the opposite direction of the removal steps.

Take out the nine door module bolts and remove the rear door module, transferring parts as necessary, with bolts to be tightened to 9 Nm (80 lb-in) upon reinstallation.

Using the speaker hole for access, release the clip on the harness from the inside.