Ford YF3Z-9C735-AA
Cruise Servo

Service and repair of the cruise control servo requires the battery ground cable to be disconnected for preventing electrical troubles since electronic modules are easily affected by static charges. You should first disconnect the electrical connector followed by removing the speed control actuator cable cap through the locking tab depression and rotation. The speed control actuator cable must be disconnected from the speed control servo pulley by easing the retaining spring while removing the speed control cable slug. You can open the throttle to decrease pressure on the speed control actuator cable while working on this process. The first step involves removing the speed control servo with its bracket by unscrewing the mounting nuts from the vehicle. Then disconnect the servo and bracket together. Complete the speed control servo separation from the bracket by removing all attachment bolts. The installation process involves performing the steps in opposite order from removal. The vehicle will display unusual driving behavior when the battery connects as it adjusts its adaptive functions during at least 16 km (10 mi) of driving autonomy.

Disconnection of the battery ground cable should be the initial step before servicing the cruise control servo but users must handle it with care to stop static electricity from harming delicate electronics. First disconnect the electrical connector after you separate the speed control actuator cable cap by engaging the locking tab then rotating it. Disconnect the speed control actuator cable from the speed control servo pulley while removing its retaining spring followed by the speed control cable slug. The throttle should be opened to decrease tension on the speed control actuator cable at this time. The installation starts with disconnecting the speed control servo along with its bracket by removing all securing nuts from the vehicle bracket which is then followed by removing both parts as one unit. You should remove the bolts that join the speed control servo to its bracket. The procedures for installation should reverse the steps of removal. A drive with specialized symptoms may occur after battery connection and disconnection because the vehicle needs to adapt its learning strategy during 16 km (10 mi) or more of driving.