1999 Ford E-350 Super Duty Fuel System Components, Fuel Delivery

Part Notes: 4 cavity, female, Switch - A/C Compressor Clutch Cycling
4 cavity, female, Switch - A/C Pressure Cut Off
4 cavity, female, Switch - Barometric Pressure

Part Notes: 4 cavity, male, Switch - Heater A/C Blower

Part Notes: 4 cavity, male, Sensor - Catalyst Monitor
4 cavity, male, Sensor - O2 (HEGO/ EGO)

Part Notes: 4 cavity, male (10 gauge), Resistor - Blower Motor (Front)
4 cavity, male (10 gauge), Resistor - Blower Motor (Rear)

Part Notes: 2 cavity, male, Sensor - Cylinder Head Temperature

Part Notes: 2 cavity, male, Solenoid - EGR Vacuum Regulator

Part Notes: 6 cavity, male, Switch - Heater A/C Blower (rear)

Part Notes: Elbow on front passenger side cylinder head.

Part Notes: This part presses into the front right manifold next to therm. housing and has one nipple for heater inlet hose

Part Notes: Aft axle tank, (Stripped Chassis/Cutaway) unleaded gas

Part Notes: 20" long. Also serviced in 9B149 kits, Cutaway/Stripped Chassis-Diesel

Part Notes: Aft axle tank, 1 1/2" I.D. x 20" long. Part is also serviced in 9B149 kits., gas
Aft axle tank, 1 1/2" I.D. x 20" long. Part is also serviced in 9B149 kits., gas, Stripped Chassis/Cutaway

Part Notes: Hose (bulk) - 5/16" tube size - 25 ft. roll

Part Notes: M6 x 1.0 x 12 hex head (screw & washer assy.) , midship tank

Part Notes: Kit, 12 cavity, male - for terminals contact FCS at 877-682-4276, Sensor - Transmission Range , Wiring Circuit: 12

Part Notes: 3 cavity, male, Lamp - Headlamp - High/Low Beam - Non-Aero

Part Notes: 1 cavity, male, Switch - Oil Sending Unit

Part Notes: Dual tube asy - heater body underbody, with heater/ac prep pack,with heater/ac prep pack deluxe

Part Notes: Pressed in block behind water pump; O-rings are W704593- S100

Part Notes: Midship tank. Also serviced in 9034. Cadbar II hose material with bonded 9A064 clamp at one end. Excludes loose clamp 9A064, gas unleaded fuel

Part Notes: (AR-51-C) retainer, 6.35mm push connect (duck bill)

Part Notes: (AI-110-DA) push connect, female straight 5/16" connector asy., 7.9mm tube x 6.3mm hole push connect; type 3

Part Notes: (AE-110-EA) push connect, female straight, 3/8" x 5/16" connector asy., 9.5mm tube x 6.4mm hose; type 3

Part Notes: 17.45mm O.D. x 19mm long, vented plug for vapor valve, 7.3L DI Turbo

Part Notes: Clip 12.5mm & clamp 18mm with tether. Attach fuel supply line to fuel rail., Gas

Part Notes: "L" shaped; 34mm High x 35mm Wide x 14mm Thick.
"L" shaped; 34mm High x 35mm Wide x 14mm Thick. , (Stripped Chassis & Cutaway)

Part Notes: Camshaft position sensor (CKP), 2 pin , Wiring Circuit: 2
Crankshaft position sensor, 2 pin , Wiring Circuit: 2

Part Notes: 3 cavity, female, Switch - Heater A/C Temperature Control

Part Notes: 2 cavity, female, Sensor - Camshaft Position, 4.6
2 cavity, female, Sensor - Crankshaft Position, 4.2, 4.6, 5.4, 6.8

Part Notes: Short A/C tube that attaches from the underbody tube to the auxiliary evaporator tube, with high output (auxiliary) heat/AC, 3/8" O.D.

Part Notes: Rubber dust cap with loop end of tether to fit over fill valve 9C112. Will retrofit for all fill valves., Gas/NGV Bi-Fuel
Rubber dust cap with loop end of tether to fit over fill valve 9C112. Will retrofit for all fill valves., NGV

Part Notes: Incl. svc. pigtail harness 9A350(mtg nuts N804495-S100 & N807585-S100). Mtg brkt is 9346. Replace the mtg nuts W520202-S309 when replacing the pump(secures 9C407/9346 to the frame)., Diesel, FROM 1/12/98

Part Notes: F5AB-14A464-AB, mates w/12A697 air charge temp sensor, 2 cavity , Wiring Circuit: 2

Part Notes: 2 cavity, male, Switch - Coolant Temperature Sending Unit

Part Notes: 2 cavity, male (10 gauge), Motor - Heater A/C Blower (Front)

Part Notes: Press in Heater hose fitting with 1/4" fitting on the side.

Part Notes: A/C low pressure tube asy, with heater/AC prep pack or prep pack deluxe, 3/4" O.D., attaches from under hood 19E558 A/C line assembly to 19752 valve located under LH front door

Part Notes: Hose asy - A/C, with high output (auxiliary) heat/AC,jumper tube attaches from underbody a/c line to auxiliary evaporator outlet

Part Notes: Plug with o'ring for access to reservoir (6658) & used on filter housing. (#1825262-C91), 7.3L, FROM 1/12/98

Part Notes: (Stripped Chassis/ Cutaway) unleaded gas, throwaway tank

Part Notes: Filler neck mounting holes at 4, 7 & 11 o'clock , Cutaway/Stripped Chassis, gas/diesel

Part Notes: 2 cavity, male, Sensor - Air Charge Temperature

Part Notes: 2 cavity, male (Tin terminals), Solenoid - Canister Vent

Part Notes: Attaches to back side of water pump under intake manifold. Slides onto the 8555. O-rings are W704593-S100., 6.8L

Part Notes: Use with midship fuel tank., Regular/Extended Vans/Wagons-Unleaded/Leaded/Diesel fuels

Part Notes: Hose (bulk) - 3/8" tube size - 25 ft. roll

Part Notes: Mounts front fuel supply/return/vapor lines (9S273/9S274/9D676). Nylon clip 3 tube holder 52mm wide w/mtg stem., Gas

Part Notes: 2 cavity, female, Fuel injector, with 6.8

Part Notes: 4 cavity, male, gold terminals, Sensor - O2 (HEGO/ EGO), 5.4

Part Notes: 2 cavity, female, Motor - Power Window - LH - Front
2 cavity, female, Motor - Power Window - RH - Front

Part Notes: #2 in illustration - Return hose, less a/c, 5/8" quick connect
#2 in illustration - Return hose, less high output (auxiliary) heater/ac, 5/8" quick connect
#2 in illustration - Return hose, with manual ac and less heater/ac prep pack or less heater/ac prep pack deluxe, 5/8" quick connect

Part Notes: TUBING - STEEL - 3/16" O.D. - SUPPLIED IN 25 FT. ROLLS

Part Notes: Kit does not include metal pipe, use 9034 with vehicle, or body builders pipe , (Cutaway) leaded/diesel fuel, without throw away tank

Part Notes: F5AB-14A464-AB, mates w/12A697 air charge temp sensor, 2 cavity , Wiring Circuit: 2
F5AB-14A464-AB, mates w/9F945 solenoid cannister valve, 2 cavity , Wiring Circuit: 2

Part Notes: 2 cavity, male - includes (1) connector (1) boot, (2) terminal pigtails,(2) heat shrink butt connectors, Speed sensor, ABS sensor in rear axle

Part Notes: 3 cavity, male, Lamp - Front Turn/Side Marker
3 cavity, male, Lamp - Park/Turn/Stop

Part Notes: 3 cavity, female, Sensor - Manifold Absolute Pressure, Diesel

Part Notes: 3 cavity, gold terminals (also reference TSB #07S57), Sensor - Camshaft Position, 7.3

Part Notes: Clip 9.0mm & clamp 18mm with tether. Attach fuel supply line to fuel rail., Gas

Part Notes: 6 cavity, 5 pin to F2UZ-19986-C blower switch

Part Notes: Radiator cooling fan motor - use w/D8BZ 14474-C (male) - Blower motor, 2-pin rectangular connector , Wiring Circuit: 2

Part Notes: Attaches to back side of water pump under intake manifold. Slides onto the 8555. O-rings are W704593-S100., 5.4L

Part Notes: 2 cavity, male, Motor - Idle Air Control
2 cavity, male, Motor - Windshield Washer Fluid Pump

Part Notes: 10 cavity, male, Actuator - Speed Control

Part Notes: 8 cavity, female, Motor - Heater/AC Blend Door

Part Notes: 16 cavity, male, Test Connector - Diagnostic

Part Notes: Gas engines, RV prep; caps F7UZ 9S303-AB, Fuel tank aux. drain tube asy., (Stripped Chassis/Cutaway)

Part Notes: (AR-51-A) retainer, 5/16" tube push connect

Part Notes: 3 tube(fuel supply/return/vapor) holder clip w/mtg stem. Also serv in 9S296., Cutaway/Stripped Chassis-Gas

Part Notes: Also serviced in 9155. Cap-Threaded end-fuel filter. Screws into top of 9N180. (#1831193-C91), 7.3L, FROM 1/12/98

Part Notes: 1 cavity, male, Capacitor - Ignition/Radio

Part Notes: Cartridge type - mounts to frame, (Cutaway)

Part Notes: #1831139-C91; Filter asy., fuel water separator., Diesel, FROM 1/12/98

Part Notes: 3 cavity, female, Sensor - Delta Pressure Feedback EGR

Part Notes: 3 cavity, female, Sensor - Accelerator Pedal Position
3 cavity, female, Sensor - Throttle Position

Part Notes: 5 cavity, female, Motor - Windshield Wiper

Part Notes: Junction plate, male (multiswitch), Switch - Power Window/Door Lock

Part Notes: 7 cavity, female, Switch - Multi-function (steering column)

Part Notes: 12 cavity, male, Sensor - Transmission Range

Part Notes: 2 cavity, male, Valve - Vapor Management, 6.8, 5.4

Part Notes: 3 cavity, male, Switch - Inertia (Fuel Pump)

Part Notes: 2 cavity, male, Fuel injector , Wiring Circuit: 2, Color: Black

Part Notes: 3 cavity, male, Alternator, except Diesel

Part Notes: 3 cavity, male, Lamp - Headlamp - High/Low Beam (Aero Lamp)

Part Notes: 3 cavity, male, Alternator, with Diesel
3 cavity, male, Sensor - Brake Fluid Level

Part Notes: 2 cavity, male, Actuator - Door Lock - Sliding Door