2000 Ford Expedition Instrument Panel

Part Notes: 115 amp Reman (same as 130 amp Original replacement requires new pulley #F65Z-10344-AA), With A/C

Part Notes: R.H., Complete asy, housing part of #8A284

Part Notes: Dual beam lamp, cartridge type, IND#578, w/o overhead console
In overhead console, w/overhead console, w/sunroof
Rear cargo lamp

Part Notes: Socket and Bulb asy - instrument cluster, IND#194

Part Notes: Socket & bulb asy for ATC control head, ATC air conditioning

Part Notes: Red Light Emitting Diode (LED) & socket for "THEFT" indicator

Part Notes: Connector for the DRL resistor, may also cut and splice from F8VZ-9F759-AA

Part Notes: Camshaft position sensor (CKP), 2 pin , Wiring Circuit: 2
Crankshaft position sensor (CKP), 2 pin , Wiring Circuit: 2

Part Notes: Kit, 12 cavity, male - for terminals contact FCS at 877-682-4276, Sensor - Transmission Range , Wiring Circuit: 12

Part Notes: Spout connector(shorting bar), replaces battery saver relay

Part Notes: Cover, lower, fuse panel, 6-cavity, on #12A581

Part Notes: Jumper to electric trailer brake controller

Part Notes: LH, complete asy, w/bracket, bulb #13466, w/fog lamps

Part Notes: Knob - control, w/ blue-green LED jewel color

Part Notes: NOZZLE AND DUCT ASY. (HEATER & A/C DEMISTER)

Part Notes: 1 3/8" diameter knob with clear jewel; For 4x4 selector switch. NOTE: Knob to headlamp switch only available in "11654" switch asy., 4x4 with center disconnect

Part Notes: A/C cycle switch - 9 and 6 o'clock locating tab - includes 14A468 lock/spacer , Wiring Circuit: 4

Part Notes: F5AB-14A464-AB, mates w/9F945 solenoid cannister valve, 2 cavity , Wiring Circuit: 2

Part Notes: 9" long - 18 gauge wire - color coded red w/stripped ends

Part Notes: Shield for heated back window wiring terminals

Part Notes: Main control located in instrument panel, with manual A/C

Part Notes: (-2*)-Dark Graphite
(-T*)-Dark Graphite

Part Notes: RH, complete asy, w/bracket, bulb #13466, w/fog lamps

Part Notes: Torpedo end caps, socket IND#13N218, w/roof console, w/o sunroof

Part Notes: Retainer - push pin type - 20mm serrated pin with 60mm x 10mm wing - general use for wiring to sheet metal or blind hole retention. Use electrical tape to secure to harness. 10 per package., Service Repair Only

Part Notes: Batt charge (Type 12)
Blower motor (Type 12)
Delayed accessory (Type 12)
Door lock (Type 12)
EEC power (Type 12)
Fuel pump (Type 12)
Heated mirror (Type 12)
Horn (Type 12)
One touch down (Type 12)
Starter interrupt (Type 12)

Part Notes: 9" long - 14 gauge wire - color coded green w/stripped ends

Part Notes: 2 cavity, male, Motor - Heater A/C Blower