2009 Lincoln MKX Catalytic Converter, Exhaust Pipe, Muffler Strap, Tail Pipe

Catalytic Converter, Exhaust Pipe, Tail Pipe Installation and Repair Tips for 2009 Lincoln MKX

• Q: How to service the Exhaust Pipe flexible section on 2009 Lincoln MKX?

  A: So as to service the exhaust flexible pipe, make sure that the vehicle is in a neutral position on a hoist. Take out the nuts holding the pipe to the Y-pipe and remove the gasket. Install new fasteners and gaskets, clean the faces of the flanges, and take off the clamp. Undo the process of installation and check on the exhaust leakages afterward.
• Q: How to Service the Muffler and Tail Pipe on 2009 Lincoln MKX?

  A: In order to service the muffler and tailpipe, place the car in neutral and use a jackstand on a hoist. Take the Torca(R) clamp off and detach the isolators with soapy water. Disassemble and disconnect the muffler and tailpipe and repeat the steps in reversing the process to install the parts, but look at the isolators. Avoid oil-based lubricants.
• Q: How to service the right-hand catalytic converter on all on 2009 Lincoln MKX?

  A: To service the right hand catalytic converter, it is important to remember that the heat shield may be serviced independently. Install with new fasteners and gaskets, clean flange faces and special torque values when reinstalling. Take out the parts that are needed such as exhaust Y-pipe and driveshaft and install the new catalytic converter with a new gasket.