FordParts
My Garage
My Account
Cart
OEM 2000 Ford Crown Victoria Sway Bar Link
Stabilizer Sway Bar Link- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Sway Bar Link found
2000 Ford Crown Victoria Stabilizer Link Part Number: F8AZ-5K484-AA
Product Specifications- Other Name: Link; Suspension Stabilizer Bar Link Kit; Sway Bar Link; Link Kit
- Manufacturer Note: BEFORE 08/27/03
- Base No.: 5K484
- Item Weight: 1.00 Pounds
- Item Dimensions: 19.6 x 6.4 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: F8AZ-5K484-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Crown Victoria Sway Bar Link
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Crown Victoria Sway Bar Link available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Crown Victoria Sway Bar Link as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Crown Victoria Sway Bar Link Parts Q&A
- Q: How to Service and Repair the Front Sway Bar Link on 2000 Ford Crown Victoria?A: A proper service and repair of the front sway bar link begins with car lifting followed by tire assembly removal. The method for sway bar link removal works equally for both the left and right side and uses the right side as the starting point for reference. The sway bar front connection requires eliminating its nut and the sway bar link needs its separate nut removal to separate. The new sway bar link needs to be placed and secured with the nut after which the front sway bar requires positioning before installing its nut. Reconnect and install both front wheel and tire assemblies before lowering the vehicle. The maintenance of suspension system integrity demands that expected fasteners must be replaced using components with same or equivalent part numbers while properly following torque specifications during reassembly.