OEM 2000 Ford Expedition Turn Signal Switch

2000 Ford Expedition Turn Signal Switch Parts Questions & Experts Answers

• Q: How to service and repair the turn signal switch on 2000 Ford Expedition?

  A: Service and repair of the turn signal switch requires starting with disconnecting the battery ground cable. Insert the ignition key into the lock cylinder followed by turning it to the RUN position to remove the ignition switch lock cylinder. To release the ignition switch lock cylinder pull out the component after using the punch to operate the tab through the shroud hole. You will need to twist both the handle on the tilt wheel as well as the shank to detach them. You must place the selector gear in its lowest setting so you can access the steering column opening cover. Then remove the cover after releasing its four clips. You should disassemble the upper and lower steering column shrouds after removing their respective three screws. First disconnect the multifunction switch by removing two screws then disconnecting electrical connectors before taking out the switch. Installation requires following the opposite removal process with special attention that battery disconnection and reconnection will cause the vehicle to relearn its adaptive strategy and this process can take more than 16 km (10 mi) of driving.