FordParts
My Garage
My Account
Cart
OEM 2000 Ford Focus Vapor Canister
Fuel Vapor Canister- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Vapor Canister found
2000 Ford Focus Vapor Canister Part Number: F65Z-9D653-AA
$85.64 MSRP: $140.91You Save: $55.27 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Reservoir Assembly; Vapor Canister Purge Solenoid
- Base No.: 9D653
- Item Weight: 2.20 Pounds
- Item Dimensions: 10.1 x 4.5 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F65Z-9D653-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Focus Vapor Canister
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Focus Vapor Canister available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Focus Vapor Canister as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Focus Vapor Canister Parts Q&A
- Q: How to Service and Repair the Vapor Canister on 2000 Ford Focus?A: A service or repair of the evaporative emission control canister must begin with disconnecting the battery ground cable to reduce the risk of fuel vapor-caused fire or explosion. A leak test needs to happen before installing the evaporative emission canister. Support the vehicle in the air before removing the evaporative emission canister tube and the canister vent solenoid electrical connector while also removing the pin-type retainer. Towards the next step disconnect the canister vent solenoid tube while being cautious of the solenoid's possible damage. First detach the EVAP canister with bracket at its mounting location and then separate the canister from this bracket. The installation process requires following the reverse order of removal steps and performing a leak test followed by the Evaporative Emission Repair Verification Drive Cycle. All practitioners must perform an assembly leak check on the canister and bracket before their installation on vehicles.