FordParts
My Garage
My Account
Cart
OEM 2000 Mercury Mountaineer Automatic Transmission Filter
AT Filter- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Automatic Transmission Filters found
2000 Mercury Mountaineer Filter Part Number: F6AZ-7A098-A
$40.76 MSRP: $64.73You Save: $23.97 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Filter Assembly; Transmission Oil Filter; Transmission Filter; Screen
- Replaces: F4TZ-7A098-A
- Base No.: 7A098
- Item Weight: 4.10 Pounds
- Item Dimensions: 15.2 x 11.0 x 0.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F6AZ-7A098-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Mountaineer Filter Part Number: F5TZ-7A098-A
$45.23 MSRP: $71.82You Save: $26.59 (38%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Screen Assembly; Transmission Oil Filter; Transmission Filter
- Manufacturer Note: 4x2
- Base No.: 7A098
- Item Weight: 2.20 Pounds
- Item Dimensions: 13.8 x 4.7 x 7.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F5TZ-7A098-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Mountaineer Filter Part Number: F5TZ-7A098-B
$45.12 MSRP: $61.40You Save: $16.28 (27%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Screen Assembly; Transmission Oil Filter; Transmission Filter
- Manufacturer Note: 4x4
- Replaces: F6TZ-7A098-AA
- Base No.: 7A098
- Item Weight: 1.60 Pounds
- Item Dimensions: 7.4 x 4.6 x 13.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: F5TZ-7A098-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Mountaineer Automatic Transmission Filter
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Mercury Mountaineer Automatic Transmission Filter available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Mercury Mountaineer Automatic Transmission Filter as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Mercury Mountaineer Automatic Transmission Filter Parts Q&A
- Q: How to Service and Repair the Automatic Transmission Filter on 2000 Mercury Mountaineer?A: The automatic transmission fluid filter service process starts with removing the transmission servo heat shield from the fluid pan rail before positioning the shield aside. A drain pan should go underneath the transmission fluid pan followed by draining the transmission fluid. The procedure starts by leaving two transmission fluid pan bolts at the front but loosening those while prying down the back section to drain the fluid before finally removing the front bolts. Depose the transmission fluid pan and throw away the gasket. Screw the transmission fluid filter out by removing its filter screw before discarding the filter. Check the condition and cleanliness of the transmission fluid pan along with its magnet. Clean the mating surfaces directly and drain transmission fluid from the cooler and lines. Before attaching the new fluid filter O-rings with Mercon(R) V; Automatic Transmission Fluid XT-5-QM, lubricate them properly. Then install the filter while checking that the wire harness stays free from compression underneath. Place the oil pan magnet inside the fluid pan and set a new gasket on top before installing the pan screws loosely. Begin by tightening the screws following a crisscross pattern and afterward reconnect the servo heat shield by clipping it onto the pan rail. Lower the vehicle while adding at least 3.7 liters (4 quarts) of Mercon V Automatic Transmission Fluid XT-5-QM and check both the fluid level and transmission operation.