Other Name: Bulb; Center High Mount Stop Light, Rear; Engine Compartment, Back Up, Turn Signal; Parking, Dome, Interior, Tail, Car; Backup Lamp Bulb; Dome Lamp Bulb; Parking Lamp Bulb; High Mount Bulb; Exterior Bulbs.
Position: Rear
Base No.: 13466
Item Weight: 0.30 Pounds
Item Dimensions: 0.4 x 0.4 x 1.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: D7TZ-13466-A
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2001 Ford Excursion Submodels:
Eddie Bauer, Limited, XLS, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
Other Name: Bulb, Turn Signal & Parking, Tail, Backup, License Plate, Side Marker, Headlight; Backup Lamp Bulb; Signal, Parking, Stop, High Mount, Cornering, License, and Parking Light Bulbs.
Position: Lower Outer
Replaces: F8DZ-13466-AB, E8AZ-13466-A
Base No.: 13466
Item Weight: 0.40 Pounds
Item Dimensions: 0.4 x 0.4 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: F5DZ-13466-B
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2001 Ford Excursion Submodels:
Eddie Bauer, Limited, XLS, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
2001 Ford Excursion Headlight Bulb
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2001 Ford Excursion Headlight Bulb available at FordPartsDeal.com. You can confidently purchase our OEM 2001 Ford Excursion Headlight Bulb as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2001 Ford Excursion Headlight Bulb Parts Questions & Experts Answers
Q: How to Safely Service and Replace a Headlight Bulb in Aerodynamic Lamps on 2001 Ford Excursion?
A: Before servicing the headlamp bulb users must turn off the headlamp switch and ignition switch. Before removing the headlamp bulb disconnect the headlamp connector while rotating the bulb retainer counterclockwise for one-eighth turn until the bulb can escape. Handle the halogen bulb with safety since its gas pressure system can break from glass scratches or drops so it should always have base contact while keeping glass surfaces untouched. New bulb installation must happen right after bulb removal to stop contaminants from entering the headlamp system as this can decrease performance outcome. To install the new headlamp bulb you must position it correctly before tightening the bulb retainer with a one-eighth turn clockwise rotation. Finally, reconnect the headlamp connector. The 9004 and 9007 bulbs have comparable looks yet they must never be used interchangeably.