Other Name: Bulb; Center High Mount Stop Light, Rear; Engine Compartment, Back Up, Turn Signal; Parking, Dome, Interior, Tail, Car; Backup Lamp Bulb; Dome Lamp Bulb; Parking Lamp Bulb; High Mount Bulb; Exterior Bulbs.
Position: Rear
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2000-2005 Ford Excursion | Eddie Bauer, Limited, XLS, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
Other Name: Bulb, Turn Signal & Parking, Tail, Backup, License Plate, Side Marker, Headlight; Backup Lamp Bulb; Signal, Parking, Stop, High Mount, Cornering, License, and Parking Light Bulbs.
Position: Lower Outer
Replaces: F8DZ-13466-AB, E8AZ-13466-A
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2000-2005 Ford Excursion | Eddie Bauer, Limited, XLS, XLT | 10 Cyl 6.8 L GAS, 8 Cyl 5.4 L GAS, 8 Cyl 6.0 L DIESEL, 8 Cyl 7.3 L DIESEL
Ford Excursion Headlight Bulb
Welcome to our website where you can discover high-quality, genuine Ford Excursion Headlight Bulb. We offer an extensive inventory of OEM Ford Excursion Headlight Bulb at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.
Q: How to service the aerodynamic headlight bulb on Ford Excursion?
A: In order to replace the headlamp bulb, both switches must be turned off. Unscrew the connector of the headlamps and manipulate the halogen bulb using the base. To replace the bulb, simply counterclockwise rotate the retainer and then replace the bulb (9004 and 9007 cannot be used interchangeably) and reconnect the connector.
Q: How to Service the Headlight Bulb for Aerodynamic Lamps on Ford Excursion?
A: In order to service the headlamp bulb, both switches should be off. Unscrew the connector and take the bulb off by counterclockwise motion of the retainer. Only use the base of the halogen bulb. Prolonged exposure to contaminants should be avoided and the use of the headlamp should never be done without the bulb. To replace a bulb, follow the same procedure in reverse.