OEM 2001 Ford Explorer Sport Trac ABS Control Module

2001 Ford Explorer Sport Trac ABS Control Module Parts Questions & Experts Answers

• Q: How to bleed the brake system after installing a new ABS Control Module on 2001 Ford Explorer Sport Trac?

  A: The correct procedure for hydraulic control unit (HCU) bleeding involves connecting a DCL cable to the data link connector (DLC) below the dash followed by the scan tool instructions for leakage termination. Users should clean the brake master cylinder filler cap before adding DOT 3 brake fluid to the reservoir. The procedure must avoid dehydration of the fluid. Connect a drain tube with transparency to the right-hand (RH) rear bleeder screw followed by insertion of drain tube end into recommended brake fluid solution in a partially-filled container. An assistant should both pump the brake pedal until firm pressure develops. Open the RH rear bleeder screw to produce a fluid stream but immediately close it when the assistant maintains pedal pressure. Bleeding should continue until clean fluid without air bubbles appears from the system while adding new fluid to the master cylinder reservoir periodically. Complete the bleeding process by opening the left-hand rear bleeder screw followed by the right-hand front bleeder screw and ending with the left-hand front bleeder screw then repeat the bleeding procedure as required. The correct use of DOT 3 brake fluid will help prevent damage to brake parts along with necessary precautions to protect your eyes as well as painted or plastic surfaces.