OEM 2001 Lincoln Town Car Fuel Rail

2001 Lincoln Town Car Fuel Rail Parts Questions & Experts Answers

• Q: How to service the fuel rail safely and effectively on 2001 Lincoln Town Car?

  A: Service of the fuel rail requires following all necessary safety measures because fuel-related parts have high flammability levels. The task starts by disconnecting the battery ground wire and reduced fuel pressure. The service starts with disconnecting fuel lines and then removing the throttle body and EGR valve alongside exhaust manifold tube. Start by disconnecting the drive belt followed by discarding the electrical connector then removing generator harness then disconnecting the harness pin-type retainer and then remove bolts and generator mounting bracket. The next step requires removing corresponding bolts then unclipping the accelerator cable with additional steps to detach the speed control actuator cable from crash brackets followed by detaching the LH heated oxygen sensor electrical connector and transmission connector from rear cylinder bracket. Set the wiring bracket to the side after unfastening the nut and bolt before disconnecting vacuum lines which then become set aside. You must first disconnect the eight fuel injectors combined with the crankcase ventilation tube and vacuum line and also remove the vacuum line from both the evaporative emission canister purge valve and the EGR vacuum regulator solenoid. After removing the studs and crash bracket you should remove the assembly of the fuel injectors together with the fuel injection supply manifold. Begin fuel injector O-ring lubrication with engine oil before installing the fuel injection supply manifold together with fuel injectors as one piece before adding the studs and crash bracket. Begin by installing the bolt along with the stud before connecting the EGR vacuum regulator solenoid and its vacuum line to the evaporative emission canister purge valve along with the vacuum line and crankcase ventilation tube. First install the eight fuel injectors with their corresponding vacuum lines before installing the bracket along with tightening its bolt and nut. After installing the LH heated oxygen sensor connector with the transmission electrical connector at the rear cylinder bracket position you must secure the accelerator cable and speed control actuator cable to their designated crash brackets before dressing the bolts. Putting the generator mounting bracket back into position and securing it with bolts should proceed as a step followed by linking the electrical connector with generator harness and harness pin-type retainer before placing the drive belt and EGR valve to exhaust manifold tube and throttle body and finishing with fuel lines connections before restoring the battery ground cable.